REAR BUMPER. Subaru Outback 2.5L CVT Limited

Bolt. Flange 6X16. that secures The Bumper Cover. Fastens The Backup Lamp to The Vehicle. Floor Pan Splash Shield. Fog Light Screw. License Plate Light Panel. A Threaded Rod with a Drive Head (such as Hex. 12 Point. torx. etc) on One End used to secure The License Plate Housing to its Mounting Point.

Nut. A Rubber Ring with a Hole in The which provides Protection Through which Fender Molding related components Through. Bumper Cover Grommet. Bumper Cover. to secure Bumper Cover. Rocker Panel Molding Grommet. Screw Grommet Spoiler. Wheel Arch Molding.

A Clip which helps secure the Bumper Corner Cover to its Mounting Point. A Securing Fastener which helps Hold the Backup Lamp Assembly in place. Bumper Cover Reinforcement Clip. Bumper Cover Rivet. Bumper Cover Spacer Panel Clip. Bumper Cover Support Rail Clip. Bumper Guide Clip. Bumper Impact Absorber Clip. Clip that fastens Hood Seal to Hood. Engine Air Intake Hose Clip. Fender Liner Retainer. Fog Light Clip. Fuel Tank Shield Clip. Grille Molding Clip. Hardware used to attach Bumper Cover to the Vehicle. Metal or Retainer to Hold the Grille to the Vehicle. Quarter Panel Extension Bolt. Radiator Support Access Cover Clip. Radiator Support Air Deflector Clip. Radiator Support Splash Shield Clip. Shield used to Direct Water / Debris away from the Floor Pan. Suspension Subframe Crossmember Clip. Tailgate Trim Cover Clip. Under Cover. Valance Panel Clip. A Threaded Rod with a Drive Head (such as Hex. 12 Point. torx. etc) on One End used to secure the Quarter Panel Extension to its Mounting Point.

Clip For The Rocker Panel Molding. Clip-2PIECE D7. Hardware used to attach Bumper Cover to The Vehicle.

M6X20. M6X20.